Automatic butt fastener for 10 mm slot

Automatic butt fastener for 10 mm slot (40R10-type slot only)

No machining is required to install this fastener.

Installation method:

    Insert the first cylinder into the screwdriver.
    Position the cylinder at the end of the profile against the groove
    Screw normally until complete insertion (the cylinder must be positioned slightly inside). The cylinder is self-tapping.
    Proceed in the same way for the second cylinder but screw in the opposite direction.
    Insert and then tighten the supplied screw.

This assembly system is particularly suitable for its anti-torsion effect.

Caution: Use at least two fasteners per joint.

Delivered by 1 kit (two cylinders + screws)