Automatic fastener for 8 mm 40x40 slotted profiles

Automatic fastener for 8 mm 40x40 slotted profiles (I-type 40R8 slot only)

No machining is required to install the automatic fastener.

Installation method:

•   Preferably use a screwdriver equipped with a hexagonal bit.
•   Position the fastener at the end of the profile against the slot.
•   Screw counterclockwise until full insertion. The fastener is self-tapping.

This assembly system is particularly suitable for its anti-torsion effect.

Caution: Use in pairs with M6 nuts (not supplied).

Delivered by 1 kit consisting of a screw and a self-tapping sleeve.

Warning: incompatible with the 8mm slot in series 30

Dimensions in mm (see diagram)

A = M12

B = 40

C = 31

D = M6

E = 6.5 diameter

F = diameter 10